LTS Studio 3D — the design module inside Low Temp Desk — gives laboratory equipment contractors a 3D refrigeration model you rotate, measure and present, built from refrigeration inputs instead of generic CAD blocks. It works in ULT freezers, controlled rooms, incubators and chillers, so the model already speaks your equipment instead of asking you to draw it line by line.
a 3D refrigeration model you rotate, measure and present, built from refrigeration inputs instead of generic CAD blocks
the customer sees the job before it is built
Yes. Laboratory equipment contractors use LTS Studio 3D on ULT freezers, controlled rooms, incubators and chillers. The module is built so the customer sees the job before it is built.
That case is the reason it exists: sample loss risk that forces backup cooling into the design. Orbit, zoom and section the model in the browser, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Dimension tags that update when you move a wall.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Validation and calibration documentation per room — the export is built to sit in that file.