LTS Studio 3D — the design module inside Low Temp Desk — gives seafood refrigeration contractors cold room layouts drawn to real dimensions, with the envelope, the doors and the mechanical package all in one model. It works in ice rooms, flake ice machines, chill rooms and freezers, so the model already speaks your equipment instead of asking you to draw it line by line.
cold room layouts drawn to real dimensions, with the envelope, the doors and the mechanical package all in one model
every cold room you build has a drawing behind it
Yes. Seafood refrigeration contractors use LTS Studio 3D on ice rooms, flake ice machines, chill rooms and freezers. The module is built so every cold room you build has a drawing behind it.
That case is the reason it exists: pull-down times measured against a boat schedule. Panel schedule with square footage and finish per wall, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Target temperature drives the estimated load shown live on screen.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Cold chain records from landing to shipment — the export is built to sit in that file.