LTS Studio 3D — the design module inside Low Temp Desk — gives walk-in cooler and freezer installers panel-by-panel layout with thickness, finish and joint direction so the box can be ordered from the drawing. It works in panel boxes, evaporators, condensing units and door packages, so the model already speaks your equipment instead of asking you to draw it line by line.
panel-by-panel layout with thickness, finish and joint direction so the box can be ordered from the drawing
the panel order matches the box that gets built
Yes. Walk-in cooler and freezer installers use LTS Studio 3D on panel boxes, evaporators, condensing units and door packages. The module is built so the panel order matches the box that gets built.
That case is the reason it exists: quoting boxes from a phone call and eating the difference when the panels do not fit. 2, 3, 4, 5 and 6 inch panel options with finish selection, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Corner, door and cutout panels called out separately.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Installation records and warranty registration per box — the export is built to sit in that file.