LTS Studio 3D — the design module inside Low Temp Desk — gives c-store refrigeration contractors condensing unit selection tied to the calculated load, the design SST and the ambient the unit will actually live in. It works in beer caves, reach-in doors, small racks and beverage coolers, so the model already speaks your equipment instead of asking you to draw it line by line.
condensing unit selection tied to the calculated load, the design SST and the ambient the unit will actually live in
the unit matches the box instead of matching the truck stock
Yes. C-store refrigeration contractors use LTS Studio 3D on beer caves, reach-in doors, small racks and beverage coolers. The module is built so the unit matches the box instead of matching the truck stock.
That case is the reason it exists: identical small builds repeated across dozens of sites. Indoor, outdoor and rooftop mounting with line-length penalty, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Refrigerant selection including low-GWP alternatives.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Per-site documentation each corporate account requires — the export is built to sit in that file.