LTS Studio 3D — the design module inside Low Temp Desk — gives laboratory equipment contractors condensing unit selection tied to the calculated load, the design SST and the ambient the unit will actually live in. It works in ULT freezers, controlled rooms, incubators and chillers, so the model already speaks your equipment instead of asking you to draw it line by line.
condensing unit selection tied to the calculated load, the design SST and the ambient the unit will actually live in
the unit matches the box instead of matching the truck stock
Yes. Laboratory equipment contractors use LTS Studio 3D on ULT freezers, controlled rooms, incubators and chillers. The module is built so the unit matches the box instead of matching the truck stock.
That case is the reason it exists: sample loss risk that forces backup cooling into the design. Indoor, outdoor and rooftop mounting with line-length penalty, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Refrigerant selection including low-GWP alternatives.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Validation and calibration documentation per room — the export is built to sit in that file.