LTS Studio 3D — the design module inside Low Temp Desk — gives cannabis facility contractors a placement tool that snaps evaporators, condensers and controls where they physically fit and where they can be serviced. It works in dry rooms, dehumidification, chilled water and precise controls, so the model already speaks your equipment instead of asking you to draw it line by line.
a placement tool that snaps evaporators, condensers and controls where they physically fit and where they can be serviced
nothing is mounted where the coil blows straight at the door
Yes. Cannabis facility contractors use LTS Studio 3D on dry rooms, dehumidification, chilled water and precise controls. The module is built so nothing is mounted where the coil blows straight at the door.
That case is the reason it exists: rooms that must hold temperature and humidity together within a tight band. Clearance envelopes per equipment type, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Roof, wall or remote condensing unit placement with line-run length.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. State-tracked environmental records per room — the export is built to sit in that file.