LTS Studio 3D — the design module inside Low Temp Desk — gives commissary kitchen contractors evaporator selection by capacity, TD and airflow, then placed in the 3D room where the throw covers the product. It works in shared walk-ins, freezer bays, prep coolers and ice machines, so the model already speaks your equipment instead of asking you to draw it line by line.
evaporator selection by capacity, TD and airflow, then placed in the 3D room where the throw covers the product
no more short-cycling coils in the corner of a long room
Yes. Commissary kitchen contractors use LTS Studio 3D on shared walk-ins, freezer bays, prep coolers and ice machines. The module is built so no more short-cycling coils in the corner of a long room.
That case is the reason it exists: shared spaces subdivided per tenant with separate cooling. Air throw shown in the model against room length, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Defrost type suggested from room temperature.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Per-tenant temperature documentation for each operator — the export is built to sit in that file.