LTS Studio 3D — the design module inside Low Temp Desk — gives contractors serving grocery chains evaporator selection by capacity, TD and airflow, then placed in the 3D room where the throw covers the product. It works in medium and low temp racks, case lineups, controls and energy management, so the model already speaks your equipment instead of asking you to draw it line by line.
evaporator selection by capacity, TD and airflow, then placed in the 3D room where the throw covers the product
no more short-cycling coils in the corner of a long room
Yes. Contractors serving grocery chains use LTS Studio 3D on medium and low temp racks, case lineups, controls and energy management. The module is built so no more short-cycling coils in the corner of a long room.
That case is the reason it exists: corporate review cycles that reject anything without a drawing. Air throw shown in the model against room length, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Defrost type suggested from room temperature.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Documented design submittals per store program — the export is built to sit in that file.