LTS Studio 3D — the design module inside Low Temp Desk — gives cannabis facility contractors line set routes measured in the model, so the length you quote is the length you pull. It works in dry rooms, dehumidification, chilled water and precise controls, so the model already speaks your equipment instead of asking you to draw it line by line.
line set routes measured in the model, so the length you quote is the length you pull
you order the line set once
Yes. Cannabis facility contractors use LTS Studio 3D on dry rooms, dehumidification, chilled water and precise controls. The module is built so you order the line set once.
That case is the reason it exists: rooms that must hold temperature and humidity together within a tight band. Equivalent length including fittings and vertical rise, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Insulation and hanger takeoff along the run.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. State-tracked environmental records per room — the export is built to sit in that file.