LTS Studio 3D — the design module inside Low Temp Desk — gives laboratory equipment contractors parallel rack rooms laid out with compressor spacing, service clearance and header routing modeled. It works in ULT freezers, controlled rooms, incubators and chillers, so the model already speaks your equipment instead of asking you to draw it line by line.
parallel rack rooms laid out with compressor spacing, service clearance and header routing modeled
the rack room is serviceable the day it goes in
Yes. Laboratory equipment contractors use LTS Studio 3D on ULT freezers, controlled rooms, incubators and chillers. The module is built so the rack room is serviceable the day it goes in.
That case is the reason it exists: sample loss risk that forces backup cooling into the design. Service clearance checked around every machine, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Header and branch routing to the case lineup.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Validation and calibration documentation per room — the export is built to sit in that file.