LTS Studio 3D — the design module inside Low Temp Desk — gives seafood refrigeration contractors drawings a refrigeration contractor actually issues: plan, elevation, equipment schedule and notes, generated from the model. It works in ice rooms, flake ice machines, chill rooms and freezers, so the model already speaks your equipment instead of asking you to draw it line by line.
drawings a refrigeration contractor actually issues: plan, elevation, equipment schedule and notes, generated from the model
you can hand a real drawing set to the inspector
Yes. Seafood refrigeration contractors use LTS Studio 3D on ice rooms, flake ice machines, chill rooms and freezers. The module is built so you can hand a real drawing set to the inspector.
That case is the reason it exists: pull-down times measured against a boat schedule. Equipment schedule with model numbers and capacities, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Revision history kept with the customer file.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Cold chain records from landing to shipment — the export is built to sit in that file.