LTS Studio 3D — the design module inside Low Temp Desk — gives brewery refrigeration contractors a heat load calculation that runs while you draw, using the envelope, the product and the usage you entered. It works in glycol chillers, fermentation jackets, cold rooms and keg coolers, so the model already speaks your equipment instead of asking you to draw it line by line.
a heat load calculation that runs while you draw, using the envelope, the product and the usage you entered
you stop guessing tonnage from the last job that looked similar
Yes. Brewery refrigeration contractors use LTS Studio 3D on glycol chillers, fermentation jackets, cold rooms and keg coolers. The module is built so you stop guessing tonnage from the last job that looked similar.
That case is the reason it exists: expansions where the new tanks arrive before the cooling capacity does. BTU/h result shown live next to the model as dimensions change, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Evaporator capacity and condensing unit size suggested from the result.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Batch temperature history the brewer keeps with the record — the export is built to sit in that file.