LTS Studio 3D — the design module inside Low Temp Desk — gives produce refrigeration contractors suction, liquid and hot gas runs routed in 3D with line sizes, risers and trap notes attached to the route. It works in ripening rooms, forced-air coolers, humidifiers and airflow control, so the model already speaks your equipment instead of asking you to draw it line by line.
suction, liquid and hot gas runs routed in 3D with line sizes, risers and trap notes attached to the route
the piping is sized on paper instead of in the parking lot
Yes. Produce refrigeration contractors use LTS Studio 3D on ripening rooms, forced-air coolers, humidifiers and airflow control. The module is built so the piping is sized on paper instead of in the parking lot.
That case is the reason it exists: airflow patterns that decide whether the pallet ripens evenly. Riser and trap warnings when velocity will not return oil, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Pressure drop per run shown before the pipe is ordered.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Room condition records buyers ask for on delivery — the export is built to sit in that file.