LTS Studio 3D — the design module inside Low Temp Desk — gives supermarket refrigeration contractors suction, liquid and hot gas runs routed in 3D with line sizes, risers and trap notes attached to the route. It works in parallel racks, case lineups, walk-ins and CO2 boosters, so the model already speaks your equipment instead of asking you to draw it line by line.
suction, liquid and hot gas runs routed in 3D with line sizes, risers and trap notes attached to the route
the piping is sized on paper instead of in the parking lot
Yes. Supermarket refrigeration contractors use LTS Studio 3D on parallel racks, case lineups, walk-ins and CO2 boosters. The module is built so the piping is sized on paper instead of in the parking lot.
That case is the reason it exists: remodels where the case lineup, the rack and the store schedule all have to line up. Riser and trap warnings when velocity will not return oil, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Pressure drop per run shown before the pipe is ordered.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Store-by-store documentation and leak-rate records the chain audits — the export is built to sit in that file.