LTS Studio 3D — the design module inside Low Temp Desk — gives produce refrigeration contractors shop drawings for submittal: dimensioned plan, equipment schedule, panel schedule and piping notes on one issued set. It works in ripening rooms, forced-air coolers, humidifiers and airflow control, so the model already speaks your equipment instead of asking you to draw it line by line.
shop drawings for submittal: dimensioned plan, equipment schedule, panel schedule and piping notes on one issued set
submittals stop being the reason the job slips a week
Yes. Produce refrigeration contractors use LTS Studio 3D on ripening rooms, forced-air coolers, humidifiers and airflow control. The module is built so submittals stop being the reason the job slips a week.
That case is the reason it exists: airflow patterns that decide whether the pallet ripens evenly. Submittal-ready PDF pack in one click, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Comments and revisions tracked against the job.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Room condition records buyers ask for on delivery — the export is built to sit in that file.