LTS Studio 3D — the design module inside Low Temp Desk — gives seafood refrigeration contractors a browser tool where you type the interior width, length and height and get the walk-in modeled in 3D with panels, doors and dimension lines already placed. It works in ice rooms, flake ice machines, chill rooms and freezers, so the model already speaks your equipment instead of asking you to draw it line by line.
a browser tool where you type the interior width, length and height and get the walk-in modeled in 3D with panels, doors and dimension lines already placed
the box is drawn and dimensioned before you leave the site
Yes. Seafood refrigeration contractors use LTS Studio 3D on ice rooms, flake ice machines, chill rooms and freezers. The module is built so the box is drawn and dimensioned before you leave the site.
That case is the reason it exists: pull-down times measured against a boat schedule. Cooler and freezer presets from 35 °F down to -20 °F with the matching insulation, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. 3D view and 2D plan of the same model, always in sync.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Cold chain records from landing to shipment — the export is built to sit in that file.