LTS Studio 3D — the design module inside Low Temp Desk — gives supermarket refrigeration contractors freezer layouts where door heaters, floor insulation and defrost realities are part of the plan, not an afterthought. It works in parallel racks, case lineups, walk-ins and CO2 boosters, so the model already speaks your equipment instead of asking you to draw it line by line.
freezer layouts where door heaters, floor insulation and defrost realities are part of the plan, not an afterthought
the freezer holds temperature the first winter and the first summer
Yes. Supermarket refrigeration contractors use LTS Studio 3D on parallel racks, case lineups, walk-ins and CO2 boosters. The module is built so the freezer holds temperature the first winter and the first summer.
That case is the reason it exists: remodels where the case lineup, the rack and the store schedule all have to line up. Door swing, strip curtain and traffic clearance checked in the model, so the design absorbs the change instead of being redrawn.
No. Studio 3D runs in the browser. You enter refrigeration inputs — dimensions, temperature, product, equipment — and the model, the load and the drawing come out of that. Evaporator placement kept off the door throw.
Yes. The design lives on the customer and the project, images and takeoffs drop into the estimate, and the approved version stays attached to the work order and the as-built.
A branded PDF with the 3D view, the plan, dimensions, equipment selection and the load assumptions. Store-by-store documentation and leak-rate records the chain audits — the export is built to sit in that file.